Hydraulic Control Valve Features, Maintenance and Maintenance
2024-08-31 10:02:16
The hydraulic control valve is a water pressure control valve, and the hydraulic control valve is composed of a main valve and its attached catheter guide valve needle ball valve and pressure gauge. According to the purpose of the use of different functions and places can be developed into a remote control float valve pressure relief valve slow closing check valve flow control valve pressure relief valve hydraulic electric control valve, multi-function pump control valve.
The hydraulic automatic control valve should be installed before the filter, and should be easy to discharge the requirements.
The water pump control valve is a self-lubricating valve body that uses water and does not need to be lubricated. If the parts in the main valve are damaged, disassemble it according to the following instructions:
1. Close the main valve front and rear gate valves first.
2. Loosen the pipe fitting screw on the main valve cover to release the pressure in the valve.
3. Remove all screws, including nuts for the necessary copper tubes in the control line.
4. Take the valve cover and spring.
5. Remove the shaft, diaphragm, piston, etc., and do not damage the diaphragm.
6. After removing the above items, check if the diaphragm and O-ring are damaged. If there is no damage, please do not compete for internal parts.
7. If it is found that the diaphragm or O-ring is damaged, loosen the nut on the shaft and disassemble the diaphragm or ring by the Zhejiang, and replace it with a new diaphragm or O-ring.
8. Check in detail whether the internal valve seat, shaft core, etc. of the main valve are damaged, if any other debris is cleared inside the main valve.
9. Install the main valve in the reverse order and replace the assembled parts. Note that the valve cannot be stuck.
Note: The inner valve generally consumes damage to the diaphragm and O-ring, and other internal parts are less damaged.
The hydraulic automatic control valve should be installed before the filter, and should be easy to discharge the requirements.
The water pump control valve is a self-lubricating valve body that uses water and does not need to be lubricated. If the parts in the main valve are damaged, disassemble it according to the following instructions:
1. Close the main valve front and rear gate valves first.
2. Loosen the pipe fitting screw on the main valve cover to release the pressure in the valve.
3. Remove all screws, including nuts for the necessary copper tubes in the control line.
4. Take the valve cover and spring.
5. Remove the shaft, diaphragm, piston, etc., and do not damage the diaphragm.
6. After removing the above items, check if the diaphragm and O-ring are damaged. If there is no damage, please do not compete for internal parts.
7. If it is found that the diaphragm or O-ring is damaged, loosen the nut on the shaft and disassemble the diaphragm or ring by the Zhejiang, and replace it with a new diaphragm or O-ring.
8. Check in detail whether the internal valve seat, shaft core, etc. of the main valve are damaged, if any other debris is cleared inside the main valve.
9. Install the main valve in the reverse order and replace the assembled parts. Note that the valve cannot be stuck.
Note: The inner valve generally consumes damage to the diaphragm and O-ring, and other internal parts are less damaged.
Cold room doors are specially designed for cold rooms, cooler rooms or refrigeration warehouse. It can be sliding type or swinging type design. And sliding type door can be automatic or manual. Made from thick polyurethane foam sandwich panel, cold room doors are with excellent therma insulation performance.
Cold Room Doors,Cold Storage Door,Cool Room Doors,Cold Store Doors, Cold Room Sliding Door, Cold Room Swinging Door, Refrigeration Door
SHANGHAI KENVO DOOR CO.,LTD , https://www.kenvodoor.com