Electric and hydraulic combination injection molding machine came out in the world

2024-07-28 06:01:06
Nissei Plastic Industry Co., Ltd. has introduced a new series of injection molding machines "FNX" that uses a pump system consisting of a servo motor and a hydraulic pressure in a driving source. This pump system is already available in the "PNX" series launched in September 2005. By using the motor only when needed, about 10% less power is consumed in the 1078kN older product. There are 4 models, "FNX80-9A / 12A" with clamping force of 784kN and "FNX110-18A / 25A" with 1078kN. In terms of selling price, FNX80-9A is 8.9 million yen and FNX110-18A is 10.5 million yen. Injection preparation time is reduced to the same electrical 45ms. Injection speed can be set between 1 ~ 300mm / second. Due to the small flux losses, drive measurements are reduced by up to 41% compared to older hydraulic presses. And further improve the repeatability, so as to control the instability of the quality of formed products to the past 1/3. For the clamping structure, and PNX series using the same direct clamping mode. It is characterized by the mold can be evenly transmitted to the mold force, long-term maintenance of parallelism. Support mold thickness mold. In addition, you can shorten the time to replace the mold.

Others Mass Flow Meter

Sealand is a trustworthy supplier of Mass Flow Transmitter, Mass Flow Sensor, Mass Flow Metre, Coriolis Metre, ATEX, IECEx & CE approved.

Sealand Mass flow meter measures the mass based on Coriolis effort. The operating principle involves inducing a vibration of the tube through which the fluid passes. The vibration, though not completely circular, provides the rotating reference frame that gives rise to the Coriolis effect. While specific methods vary according to the design of the flow meter, sensors monitor and analyze changes in frequency, phase shift & amplitude of the vibrating flow tubes. The changes observed represent the mass flow rate and density of the fluid.

Features

● Measurement is not influenced by flow density, viscosity, temperature & pressure;
● Low requirement of straight pipe, because nothing inside holds back the flow;
● Low power dissipation; stable zero point; better accuracy;
● Meter is ARM system with 3 calculators to count density, temperature & mass flow rate; ● Transmitter is assembled by surface mounting technology with self-inspection function; ● ATEX approved(excluding Transmitter F210). Cert. No. TPS 18 ATEX 04516 001 X

Mass Flow Transmitter, Mass Flow Sensor, Mass Flow Metre, Coriolis Metre

Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeter.com