How to Solve the Problem of Poor Sound Quality of Network Cameras
1: first determine whether the network camera audio input is: LINEIN (linear level)
2: If it is to determine the LINE audio input port, then check whether the microphone power supply is normal, check the connection of the pickup is correct.
If the above two cases are determined, the sound quality recorded by the webcam is still very vague or has no sound?
1: First check, pickup audio signal output connection, the general network camera audio input connector is 3.5 headphone connector, then the corresponding pickup audio signal line, it must be transferred to 3.5 headphone connector.
2: It should be noted that although you plug in a 3.5 headphone connector, but the 3.5 connector, he is divided into two channels and single channel points, that is, stereo and mono, check your 3.5 connector is dual channel or Single channel.
3: If the confirmation is mono, then the positive electrode of the pickup is connected to the positive electrode of 3.5, and the negative electrode is connected to the negative electrode. If you have two channels, then there will be a three-core cable. The negative electrode of the pickup is connected to the negative electrode of 3.5, and the positive electrode is connected to the other two wires corresponding to the 3.5 connector, which are the left and right channels respectively.
4: There is also a situation where the audio input of certain brands of network cameras now has both: LINE and MIC input, that is to say an audio input port, he may be the left channel is the LINE right channel is the MIC, In such a situation, you cannot connect the left and right channels together to connect the positive pole of 3.5. For example, if the negative electrode is connected to the negative electrode, then the positive electrode is connected to one of the 3.5 connectors, and then listen to the sound. If it is not normal, change it to another audio cable. But can't carry on the parallel connection of the left and right channels, also forbid to use the monophonic 3.5 joints, must use the dual-channel joint.
The 3.5 connector is a standard interface in the world. If the 3.5 headphone connector has two black lines, it represents a dual channel interface. The two black lines are actually from the insulating ring. The sharpest part at the top of the 3.5 connector is stereo left. Channel, the middle of the insulation ring is the right channel, and the negative is the ground at the root. If it is a mono 3.5 connector, the opposite is to see only a black insulating ring, the tip is positive, the root to the negative!
Hexagon nuts (also known as finished hexagon nuts) are available in ASTM A563-A and are compatible with mild steel Bolts, such as ASTM A307, ASTM F1554 Grade 36, SAE Grade 2 and AASHTO M183. SAE Grade 5 and Grade 8 nuts are also available in finished style. Since hot-dip galvanizing usually increases the thickness of the threaded part of the fastener by 2.2 to 5 mils, the thread size of the galvanized hexagon nut is too large to compensate for the anti-corrosion coating on the bolt.
Chinese hex nut manufacturer Hongchuang Hardware provides hex nuts of various materials, such as carbon steel, stainless steel, alloy steel, titanium, etc.
Carbon Steel Nut,Galvanized Nut,Carbon Nuts,Carbon Steel Hex Nut
Taizhou Hongchuang Hardware Co., Ltd. , https://www.jstaizhouhongchuang.com