6 inspections before the bubble machine
2024-03-03 05:07:36
The six major inspections before the bubble machine is turned on are as follows:
1. Check the power supply, vacuum system, air pressure system and cooling system before starting each time. After the equipment is started, check whether the rotation direction of each rotating part is correct. Pay attention to check the lubrication of each lubrication part. The electrical instrument should be in accordance with the regulations. Normal maintenance and maintenance.
2. The equipment should be assigned a special person to operate, and the extruder screw should not be idling without material, so as to avoid the screw and the barrel being scratched. After the shutdown, if there is stock in the barrel, before starting the machine again, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the temperature can be turned on for 30 minutes to be turned on. So as not to damage the machine.
3. When feeding the hopper, it must be clean and strictly prevent metal debris, sand and small tools from entering the material port to prevent damage to the barrel and screw. If abnormal noise is found during operation, stop it immediately.
4. If the screw is taken out from the barrel for some reason, it should be properly handled to prevent deformation. If it is not replaced in the barrel for a long time, the screw must be hung vertically to prevent bumping, bending and permanent deformation. The surface of the screw is coated with anti-rust oil for protection.
5. The use, adjustment, maintenance and maintenance of temperature controllers, electronic instruments, electrical switches, etc. shall be carried out in accordance with the procedures and product specifications.
6. In addition to daily maintenance, regular maintenance should be carried out. The die should be thoroughly cleaned every three months. The grease should be replaced every three months for each bearing, and the lubricating oil should be replaced once every six months. Every two years, the equipment will be overhauled as a whole.
U Nails
U nails refer to a kind of fasteners with two-pronged shanks. These U nails are usually used for attaching the mesh fences to wooden posts and frame, hence the name fencing staples. These practical nails can fix the wire, rope even Barbed Wire to the ground, wooden post or stakes. Therefore, people like to use them in agriculture & gardening, viticulture & other fruit growing, animal coops & plant trellises construction.
U Shaped Nails,Galvanized U Nails,Pvc Coated U Nails,Insulation U Nails
HENGSHUI YUZHENG IMPORT AND EXPORT CO., LTD. , https://www.yuzhengnails.com